111 has a single touch panel which connects all of the classrooms monitors and inputs into one easy to use touch screen.

The primary screen which will be displayed at the beginning of a session is shown below, and has two primary options - "Dual Projectors" and "Projectors and Monitors"

Note: When "System Off" is selected the classroom takes approximately two minutes to shut down everything and then reboot for operation.

Extron TouchPanel System Settings

School of Information Studies > Hinds 111 > image2018-8-6_15-2-24.png

Main Display Controls

Power - Main power controls for the projector display at the front of the room.
Main Display Settings - The options here are PC Monitor Display, HDMI, and 5 alternative HDMI options with ports throughout the room {The HDMI Inputs are located on the walls near outlets}. Touch any of these while highlighting your desired display above (Left/Projector/Right) to change.
To ALL - By touching this option, the display/volume settings currently selected will be pushed TO ALL other display settings on this Extron system.

If video is not outputting and you have consulted the above options, make sure video mute is NOT highlighted.

Volume Settings

Main Volume Settings - Up and Down arrows will raise volume for the speakers throughout the classroom.

If audio is not outputting, make sure mute is NOT highlighted.

Teaching Station Controls

System Utilities Select this option to open up the following display.

Teaching Station Monitor - Similar to the above display options, these will change the output of the monitor on the teaching station relative to the highlighted option.
Left/Right Front/ Right Middle - Selecting the options below these headings will change the display of the mobile monitors located throughout the room.

Other Instructional Resources