...

40 seats, calendar , For booking contact: iSupport@syr.edu

Overview of Classroom Setup

At the front of the room, you will see the two HDTVs, Camera (Front), and the Teaching Workstation.

At the back of the room, you will see Camera (Rear).

Image Modified

...

Teacher's Workstation

• The teaching workstation consists of multiple parts which allow you to control the classroom.  The teaching workstation sits on wheels allowing it to be mobile.

...

Extron Touch Control Panel

Image RemovedImage Added

Note: When "System Off" is selected the classroom takes approximately two minutes to shut down everything and then reboot for operation. 

...

• Teaching Station Monitor - Similar to the above display options, these will change the output of the monitors on the teaching station relative to the highlighted option.

COVID-19 Classroom Accommodations

Each classroom in Hinds Hall is now equipped with additional technology for professor & students. The technology; which includes Cameras for video recording, Headset Docks to support faculty deployed headsets, etc. servers to facilitate proper practices in the classroom while adhering to COVID-19 guidelines.
The following documentation will highlight features and controls for the new tech, as well as explaining its functionality from room to room in Hinds Hall.

Wireless Headset

On the teaching station, you will find a headset dock ready for pairing with your personal wireless headset for virtual classroom uses. In the picture below, you will see an example of a headset dock and a headset located at the front of the room.

Image Added

Connecting your Headset to the Dock/Classroom

To ensure that your headset successfully pairs with the headset dock, connect the headset to the dock, as seen in the image below, and wait until you hear a beep come from the headset dock. In addition, you can also confirm your headset is paired to the dock by looking at the headset icon located on the side of the dock (see no. 5 located in Headset Components).

Image Added

Headset Components

In the image below, you will see the following headset components:

• 1 - Volume up
• 2 - Volume down
• 3 - Call answer/end button
  • LED lit when on a call
• 4 - Battery icon
  • Solid white: full charge
  • Blinking white: charging
  • Solid red: very low
• 5 - Headset icon
  • Blinking white: headset pairing to base
  • Solid white: headset paired to base
  • Solid red: headset not paired to base

Image Added

Other Instructional Resources

...