Content Comparison

...

• ALWAYS PROVIDE ADEQUATE INFEED AND OUTFEED SPACE WHEN OPERATING THE SANDER.
• KEEP THE WORK AREA CLEAR OF ALL EXTRANEOUS MATERIALS, TOOLS AND TRIP HAZARDS.
• ALWAYS STAND TO THE SIDE OF THE SANDER WHILE FEEDING THE WORKPIECE.
• DO NOT FEED MATERIALS INTO THE MACHINE FROM THE OUTFEED SIDE!!!
• DO NOT REMOVE MORE THAN 1⁄32" FROM THE SURFACE OF THE WOOD STOCK IN ONE PASS.
• INSPECT YOUR STOCK BEFORE SANDING. Never sand stock with nails, staples or other foreign objects, which may be embedded in the surface. Do not sand lumber with loose knots or knots that may become loose during sanding.
• DO NOT ATTEMPT TO REMOVE JAMS UNTIL POWER IS DISCONNECTED.
• DO NOT SAND WORKPIECES BEYOND THE PARAMETERS LISTED IN THE DESCRIPTION.
• GIVE THE WORK YOU ARE DOING YOUR UNDIVIDED ATTENTION.
• KEEP HANDS OUTSIDE THE MACHINE. NEVER REACH UNDER THE GUARDS TO TRY TO CLEAR STOCK THAT STOPS FEEDING. DO NOT CLEAR CHIPS AND SAWDUST WITH HANDS; USE A BRUSH.
• DO NOT USE THIS SANDER AS A WORK TABLE.
• ALWAYS USE THE DUST COLLECTOR WHEN OPERATING THIS MACHINE.

Thickness Sander

Basic Operating Procedure

...

1. Connect power supply to machine. – Display remains dark.
2. Turn on main power switch (A). – Display will illuminate. Racetrack (G) may flash continuously, indicating that emergency stop is still engaged.
3. Rotate emergency stop (D) clockwise to disengage stop.
4. Turn on drum motor by firmly pressing switch (B) – Illuminated circle (J) will run, and “ON” will illuminate.

...