...
The scanner is very lightweight and thus should be handled with utmost care. The scanner only works when plugged in to a power supply so the first step is to connect the power cord to the power outlet located at the back of the scanner and make sure it is screwed tight. A better alternative for flexibility and increased mobility is to connect the battery pack instead of the scanner's original power cord (Note: these two cords are different and should not be interchanged). A blinking green light on the handle of the scanner should indicate that it is on. Second step is to insert the usb cable on the side of the scanner and connect it to the computer’s usb port. Before you start scanning, make sure Artec Studio 14 is open and recognizes the scanner. Keep the object to be scanned at a good distance from the scanner for best results. 
The Artec 3D Scanner can be retrieved from the IT Support at the Syracuse SOA through appointments. The scanner comes with a laptop which has Artec Studio 14 pre-installed and a battery pack
How to scan with Artec Eva 3D Scanner
...